Holtgreven GSE-355 I.S. - Manual (Page 79)

70
Setpoint Selection Function Description
P5107.0 Start 1 Setpoint 1 activation method.
P5108.-- Targ 2 Ingredient 2 target value.
P5109.-- PA 2 Pre-act 2 value (final cutoff for ingredient 2).
P5110.1 Learn 2 Learn feature for pre-act 2 enabled.
P5111.0 Start 2 Setpoint 2 activation method.
P5116.1 Pause Keypad press invokes pause mode.
P5117.-- Targ 3 Ingredient 3 target value.
P5118.-- PrAc 3 Pre-act 3 value (final cutoff for ingredient 3).
P5119.1 Learn 3 Learn feature for pre-act 3 enabled.
P5120.0 Start 3 Setpoint 3 activation method.
See Key-In Parameters on page 43 for instructions on using front panel keys for entering data.
A
CTIVATION
M
ETHOD
(B
ATCH
)
The filling of each ingredient begins when one of three selectable start functions occur. Each ingredient may have its
own start function. The deactivation of the setpoint is automatic. The desired targets may be based on net weight or
quantity (if counting is enabled). All ingredients must be based on the same parameter. See Activation Methods
(General) on page 63 for details on activation methods.
Batch
Status
Annunciator Status Setpoint Status (Requires Setpoint Option Board)
Fill 1 SP 1 Illuminated
Relay 1 Contacts Closed,
Relay 2 and 3 Contacts Open
Fill 2 SP 2 Illuminated
Relay 2 Contacts Closed,
Relay 1 and3 Contacts Open
Fill 3 SP 3 Illuminated
Relay 3 Contacts Closed,
Relay 1 and 2 Contacts Open
P
RE
-
ACTS
(B
ATCH
)
Pre-acts 1, 2 and 3 specify the final cutoff for each respective ingredient. See Per-acts (General) on page 64 for pre-act
details.
L
EARN
F
EATURE
(B
ATCH
)
Each batch pre-act has the learn feature available which allows the indicator to automatically adjust the final cutoff
based on changing environmental conditions. See Learn Feature (General) on page 64 for ‘learn’ feature details.
P
AUSE
F
EATURE
(B
ATCH
)
The standard pause feature (keypress, remote key closure or both) is available for the batch operation. See Pause
Feature (General) on page 64 for ‘pause’ details.
C
HANGING
T
ARGETS FROM THE
W
EIGH
M
ODE
(B
ATCH
)
When Discharge is configured in the setpoint setup, Targ 1 automatically becomes an available mode for the ! key.
An entry followed by 1 or ( changes Targ 1. Pressing 1 or ( alone allows access to the subsets. PA 1 and