Holtgreven GSE-355 I.S. - Manual (Page 95)

86
7. Press to toggle through the numbers to enter the seconds. The seconds do not have to be
entered. Press 1 to bypass entering the seconds.
DISPLAY READS X 16.32.4
8. Press 2 once to move the cursor. Press to select the next digit.
DISPLAY READS X 16.32.41
9. Press 1 twice to accept the time entry. The date and time are now saved until power to the
indicator is lost. The display will be returned to the weigh mode.
DISPLAY READS X 0.00
Time and Date Setup (Model 355)
The time and date feature is stored as non-volatile (time/date setting will not be lost when the unit power is
reset). The time/date parameter is available in the first two fixed transmits (See Transmit Selection on page 50)
and can be included in a custom transmit (See Custom Transmit Setup on pag 55).
Upon power up and with P502 set to Enabled, the display will toggle Enter ~ Date~01.01.70. If the date is
acceptable, press ( .
To enter the date from the Enter~date~01.01.70 prompt
EXAMPLE: 01.09.04 (January 9, 2004)
1. Key in the date in the following format:
DISPLAY READS X 01.09.04
2. Press ( to except the date and move to the time entry. Press ( again to bypass the time entry.
To enter the time from the Enter~tine~00.00.00 prompt
EXAMPLE: 16.32.41 (4:32:41 P.M.)
1. Key in the date in the following format:
DISPLAY READS X 16.32.41
2. Press ( to except the time and move to the weigh mode.
RS-485 Multi-Drop Network Setup and Operation
Table 27: RS-485 Network Parameters
P ARAMETER
S ETTING
D ISPLAYED
N AME
D ESCRIPTION
T YPE / CHOICES
(*=D EFAULT )
P250.00 rS485
Enable or disable RS-485
network option.
Disbl*, Enabl
P251.00 Addr
Specifies the address of
the controller for RS-485
Multi-Drop
communications.
Numeric Entry:
Disabled (0*) and
4 – 254