Holtgreven GSE-355 I.S. - Manual (Page 50)

41
Entering the Setup Mode (Model 355)
To prevent accidental changes to the Indicator Setup, a sequence of keystrokes is used to gain access to the Setup
Mode:
!
(
These keystrokes must be made within five seconds, or the indicator will return to the Weigh Mode.
To access the Setup Mode:
1. From the Weigh Mode, key in
!
DISPLAY READS X Setup ~ Enter Code
2. Key in
(
DISPLAY READS X Chgs ~ Poss!
P110.— — ~ F.S.= ~ 100
To access Setup in a view-only mode:
3. From the Weigh Mode, key in
!
DISPLAY READS X Setup ~ Enter Code
4. Press (
DISPLAY READS X No ~ Chgs
P110.— — ~ F.S.= ~ 100
Selecting a Parameter
To advance to the next parameter:
1. Press !
DISPLAY READS X P111.09 ~ 1Grad ~ 0.01
2. Press !
DISPLAY READS X P112.05 ~ Ztrac ~ 0.5 d
3. Continue pressing ! to advance through all setup parameters.
To access the previous parameter (Model 350):
1. Press
When exiting the Setup Mode, the Model 350/355 prompts whether to enter the Calibration Mode. (See
Chapter 5: Calibration for Calibration Mode procedures). The display will then prompt to save any
changes.