Dell C2665dnf Color Laser Printer - Manual (Page 259)

Login Error
NOTE: Login Error feature is available only when Panel Lock Control is set to Enable.
Purpose:
To specify the number of error entry attempts allowed when you log in as an administrator in the Admin
Settings and Report/List menu.
Values:
Off * Does not allow an administrator to log in after one error entry attempt.
On 5 * Sets the number of error entry attempts allowed when an administrator logs in.
Available Range: 1-10
NFC Authentication
Purpose:
To specify whether to enable the authentication using the NFC authentication card.
Values:
Disable Does not permit the authentication using the NFC authentication card.
Enable * Permits the authentication using the NFC authentication card.
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
USB Port
NOTE: USB Port feature is available only for the USB port on the rear of the printer.
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on
again.
Values:
Disable Disables the USB interface.
Enable * Enables the USB interface.
PS Data Format
Purpose:
To specify PostScript Level3 Compatible communication protocol for a parallel interface. You can configure the PS
Data Format settings for the wired network. The change becomes effective after the printer is turned off and then on
again.
Values:
Auto Used when auto-detecting the PostScript Level3 Compatible communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP* Used when the communication protocol supports both ASCII and binary data to switch
between them according to the specified control code.
Understanding the Printer Menus 257