Dell C2665dnf Color Laser Printer - Manual (Page 229)

Transmit Key Specifies the transmit key from WEP
Key 1 * , WEP Key 2, WEP Key 3, and
WEP Key 4.
WPS Setup
NOTE: WPS Setup is available only when the printer is connected using the wireless network.
Purpose:
To configure the wireless network using WPS.
Values:
Push Button Control * Start Configuration Configures the wireless setting with WPS-PBC.
PIN Code Start Configuration Configures the wireless setting using the PIN code assigned automatically by
the printer.
Print PIN Code Prints the PIN code. Confirm it when entering PIN assigned to the printer
into your computer.
IP Mode
Purpose:
To configure the IP mode.
Values:
Dual Stack * Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.
TCP/IP
Purpose:
To configure TCP/IP settings.
Values:
Get IP Address AutoIP * Sets the IP address automatically. A random value in the range of 169.254.1.0
to 169.254.254.255 that is not currently in use on the network is set as the IP
address. The subnet mask is set as 255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address manually on the
operator panel.
IP Address When an IP address is being set manually, the IP is allocated to the printer
using the format nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127 and any value in the
range of 224 to 254 cannot be specified for the first octet of a gateway
address.
Subnet Mask When an IP address is being set manually, the subnet mask is specified using
the format nnn.nnn.nnn.nnn. Each octet that makes up nnn.nnn.nnn.nnn is
a value in the range of 0 to 255.255.255.255.255 cannot be specified as the
subnet mask.
Understanding the Printer Menus 227