Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 92)

Publication 1757-IN032B-EN-P - April 2001
1-72 System Software Upgrade Procedures
Synchronizing Other Files
The Primary SERVERA node automatically transfers ProcessLogix
database information to the Secondary SERVERB node. This transfer
includes any changes in configuration data, such as points and displays.
Navigate in Knowledge Builder to Server/Client Configuration Guide
⇒
Configuring and Monitoring a Redundant Server System
⇒
Synchronizing
Other Files for more information.
If you previously configured the flbkup.def file for an earlier release, you
must re-configure it for R320.0.
Reconfiguring Other RSLinx Clients
Refer to Reconfiguring Other RSLinx Clients on page 1-40.
Reloading the 1757-PLX52 Database
Refer to Reloading the 1757-PLX52 Database on page 1-40 to check
Control Builder operation and to download the database to the
1757-PLX52.
Initiating Redundant Controller Switchover
For ProcessLogix systems with redundant controllers, refer to Initiating
Redundant Controller Switchover on page 1-41.
Enabling the ProcessLogix OPC Server
Refer to Enabling the ProcessLogix OPC Server on page 1-42. Be sure
to enable the OPC Server on both SERVERA and SERVERB.
Backing up a ProcessLogix Server to Tape
If your PC has a tape drive, refer to Backing Up a ProcessLogix Server
to Tape on page 1-6 to back up your server to tape.
Creating an Emergency Repair Disk
Refer to Creating an Emergency Repair Disk on page 1-43.