Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 130)

Publication 1757-IN032B-EN-P - April 2001
3-2 Full PC Software Installation Procedures
•
Completing installation
•
Installing Service Pack 6a
•
Configuring virtual memory
•
Converting to NTFS (if required) after Windows NT has been
installed
•
Setting COM ports
Use the manufacturer’s instructions to supplement information in the
remaining subsections, as required.
Starting the Windows NT Installation
Use the following procedure to start the installation of the Windows NT
4.0 software.
This procedure assumes that:
•
All network cards are installed in the PC and they are set to the
correct IRQs.
•
All supporting ProcessLogix system hardware is installed and
connected to the PC.
•
The PC meets specified hardware and software requirements.
Navigate in Knowledge Builder to Server and Client Installation
Guide
⇒
Before Installing ProcessLogix
⇒
Hardware and Software
Requirements for more information.
•
All manufacturers related driver diskettes are available to complete
the installation.
If you received your PC from the manufacturer with NT pre-installed,
skip to Installing Service Pack 6a for Windows NT 4.0 on page 3-9.
1. With the PC turned off, insert the Windows NT Setup Disk 1 into
the floppy drive.
2. Turn on the PC and follow the on-screen prompts to remove and
insert the Windows NT Setup Disks 2 and 3 when instructed to do
so.
IMPORTANT
If you are installing software from a network Server,
contact your network administrator for information on
starting the setup process.