Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide - Manual (Page 56)

Publication 1757-IN032B-EN-P - April 2001
1-36 System Software Upgrade Procedures
2. Key in this command in the Open entry field:
>ntools -25 -c -nl -pit -pg -u<
and click OK to launch Network Tools.
3. Click OK to acknowledge the warning about monitoring through
Control Builder.
4. Click Resume to initiate network scan.
5. When network nodes appear under the Desktop tree icon, click the
01 CNB icon.
6. In the graphic pane, select the Supervisory Uplink CNB and click
Change ControlNet Parameters .
7. Change UMax to 24 and click OK.
8. Click Yes to confirm the action.
9. Click OK.
10. Close NTOOLS.
Updating the 1784-PCIC Network Address
1. Click Start
⇒
Programs
⇒
Rockwell Software
⇒
RSLinx
⇒
RSLinx
to call up the Rockwell Software RSLinx window.
ATTENTION
!
Before continuing, you MUST exit all ProcessLogix
applications and stop all ProcessLogix services.
Refer to Stopping ProcessLogix Applications and
Services on page 1-8.