Platform system configuration definitions – Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide User Manual
Page 242

Publication 1757-IN032B-EN-P - April 2001
7-2 Performance and Capacity Specifications
Please refer to the table below to review the hardware requirements for a
new R320.0 ProcessLogix server or client system. ProcessLogix Clients
require a Windows NT operating system to support the multiple-user
configuration nodes architecture that is possible with R320.0
ProcessLogix systems.
Platform System Configuration Definitions
Small System
A small configuration may consist of 1 non-redundant Server with 1
Station or a redundant server pair. The system typically includes only
passive monitoring and occasional report generation.
Medium System
A medium configuration may consist on 1 non-redundant Server and
multiple Stations or a Redundant Server pair with no more than 2
additional Stations. This type of system includes 1 or 2 Stations actively
monitoring and occasional report generation.
Large System (Windows NT workstation as the operating system)
A large configuration may consist of a Non-redundant Server and up to
10 stations or a Redundant Server pair and up to 8 stations. These systems
typically include active monitoring from multiple Stations with or
without multiple locations and random report generation.
Table 7.A Server Requirements
Base
Dell OptiPlex GX200
Processor
800Mhz,Pentium III, 133Mhz Front Side Bus
Integrated Functions
4X AGP Video w/8MB of Memory, Audio, 512KB Cache 10/100 NIC
Mouse
MicroSoft Intellimouse
Keyboard
Quietkey Spacesaver 104-Key, US
System RAM
256MB, ECC PC700, 1 RIMM
CD-ROM
40X SCSI
Floppy Drive
1.44MB, 3.5"
SCSI Controller
Adaptec 29160N Controller
Hard Drive
9.1GB Minimum U2W, 10,000 RPM, SCSI
Tape Drive
10/20 G, SCSI, TR-5, Tape Backup Unit
Network
NIC, 3COM 3C905C Integrated Network Adapter Card, RJ45
I/O Expansion
3 PCI, 2 shared, 2 ISA
Software
MicroSoft NT4.0 (Service Pack 6a), NTFS
All hardware component drivers