Installing processlogix software on a clean pc, Installing processlogix software on a clean pc -16 – Rockwell Automation 1757-SWKIT3200 ProcessLogix R320.0 Installation and Upgrade Guide User Manual
Page 144

Publication 1757-IN032B-EN-P - April 2001
3-16 Full PC Software Installation Procedures
Installing ProcessLogix
Software on a Clean PC
The following table lists the items that you MUST complete before
attempting to install the ProcessLogix software. If you are installing
ProcessLogix software on a redundant Server pair you must complete the
items on both SERVERA and SERVERB.
Step Item:
Refer to page:
1
2
Checking Required System Settings
3
Installing Service Pack 6a for Windows NT 4.0
4
Installing Internet Explorer 5.01
5
Upgrading Data Access Components
6
Installing ProcessLogix Knowledge Builder Software
7
IMPORTANT
If you are installing ProcessLogix software on a
Redundant Server pair, be certain that the computer
names end with the letters A and B for the Primary and
Secondary Servers, respectively. For example, use the
name PLX1A for the Primary Server (SERVERA) and
PLX1B for the Secondary Server (SERVERB)
IMPORTANT
If you have redundant Servers, you must install
software on the SERVERA node first. Then complete
the software installation process again for the
SERVERB node.
You must install the ProcessLogix Server on the same
partition on both the primary and backup servers and
that their directory structures match.
For example, if you install the ProcessLogix Server to
c:\honeywell\server on the primary server then it
should be installed to the same location on the backup
server.
Synchronization problems have been encountered by
customers installing the ProcessLogix Server to
c:\honeywell\server on the primary server and to
d:\honeywell\server on the backup server.
IMPORTANT
Although not recommended, if you do not want to
install a software component, just click Cancel on the
Welcome display to abort the installation.