Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide User Manual
Page 37

Publication 1757-IN510A-EN-P - October 2003
Operating System Installation Procedures 2-17
e. Click
OK to return to the Networking Components window.
1 7. Click Nex t.
1 8. Repeat steps 15-16 for additional network cards.
1 9. At the Workgroup or Computer Domain window:
a. Select the
No, this computer … option.
b. Enter an appropriate Workgroup name.
c. Click
Nex t.
At this point in the installation, Setup finishes installing Windows
2000. This takes some time depending on your hardware
configuration.
20. At the Completing the Setup Wizard window, remove the
Windows 2000 Professional CD and click
Finish.
The PC restarts.
21 . If a Network Identification wizard opens, click Cancel.
Clean System Windows 2000 Professional Installation is complete.
Return to the checklist that led you to this task.
IMPORTANT
IP Addresses are critical to the communication of
the system. Rockwell Automation suggests, when
possible, to utilize a Private Network for the control
system, not connected to any other networks. This
isolates the control system from interference from
any business communication.
In some organizations it is important for these
addresses to be controlled by the IT organization.
Consult your company’s practices and IT
organization for the appropriate IP address
information. It is necessary to use valid IP
information to integrate the ProcessLogix Control
system with the business network.
TIP
All systems which are configured for this Process
Control System should utilize the same Workgroup
name for easier operations.