Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide User Manual
Page 19

Publication 1757-IN510A-EN-P - October 2003
ProcessLogix R510.0 Installation Introduction 1-3
ProcessLogix R510.0 Servers require the Windows 2000 Server
operating system. The following table lists the ProcessLogix Server
Install Options. This table also applies if you have a redundant Server
pair. During the installations, the procedures refer you to the
appropriate redundant Server sections.
Table 1.B ProcessLogix R510.0 Server Install Options
Type of Install:
Refer to:
Clean Install
The Clean Install is a clean machine installed with
ProcessLogix R510.0 Server software. That is, the
installation begins with formatting the hard disk and
installing Windows 2000 Server.
ProcessLogix Software Installation
on a Clean PC on page 3-1.
Upgrade from R500.1, Option 1
1. Backup your data.
2. Complete a clean install.
Option 1: Upgrading R500.1 Server
to R510.0 - Clean Install on page
4-1.
Upgrade from R500.1, Option 2
1. Backup your data.
2. Uninstall your current ProcessLogix software.
3. Install ProcessLogix R510.0.
Option 2: Upgrading R500.1 Server
to R510.0 on page 4-2.
Upgrade from R400.0 SP2, Option 1
1. Backup your data.
2. Complete a clean install.
Option 1: Upgrading R400.0 SP2
Server to R510.0 - Clean Install on
page 4-3.
Upgrade from R400.0 SP2, Option 2
1. Backup your data.
2. Uninstall your current ProcessLogix software.
3. Install ProcessLogix R510.0.
Option 2: Upgrading R400.0 SP2
Server to R510.0 on page 4-4.
Upgrade from R320.0
ProcessLogix R510.0 requires that you replace your
R320.0 current installation with new hardware and
operating software for the Server.