Rockwell Automation 1757-SWKIT5100 ProcessLogix R510.0 Installation and Upgrade Guide - Manual (Page 157)

Publication 1757-IN510A-EN-P - October 2003
ProcessLogix Client Installation and Upgrade Procedures 5-31
1 2. Click Cancel at the Unable to connect prompt, if applicable.
1 3. Click Station ⇒ Exit.
1 4. Click Yes to exit Station.
Setting Up a Station With a Redundant Server Pair
If you are setting up Station with a non-redundant Server, refer
to Setting Up a Station With a Non-redundant Server on page 5-29.
Complete the following steps to set up the ProcessLogix Client to
access data in networked ProcessLogix redundant Server.
1 . On SERVERB, click Star t ⇒ Pr ograms ⇒ Pr ocessLogix
Ser ver ⇒ Start-Stop Pr ocessLogix Server to call up the
ProcessLogix Server dialog box. Verify that the Server is running
and close the dialog box.
OR
2. Repeat Step 1 on SERVERA to verify that the ProcessLogix
Server is also running on this node.
3. On the Client, click Star t ⇒ Pr ograms ⇒ Pr ocessLogix Client
Softwar e ⇒ Station.
4. Click Cancel at the Unable to connect prompt, if applicable.
5. Click Station ⇒ Connect to call up the Station Connect dialog
box.
6. Click New Connection.
TIP
You must define the appropriate Station items in
Quick Builder on the Server in order for the Client
Station to connect.
Navigate in Knowledge Builder to Server and Client
Configuration Guide
⇒
Configuration Tutorial
⇒
Defining a Station for more information.