Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 286)

Publication 1758-UM002D-EN-P - October 2010
286 Extension Modbus Protocol for DataSite Controllers (1758-FLO)
There is no event code for command number 4.
Command Number 5: Disable/Enable the Flow Calculation
Use command number 5 to enable or disable the flow calculation for a meter
run.
49028 u_int W Pass code for user
49030…49034 — — Reserved
49035 u_short R Device name 1
49036 u_short R Device name 2
49037 u_short R Device name 3
49038 u_short R Device name 4
49039 u_short R Device name 5
49040 u_short R Device name 6
49041 u_short R Device name 7
49042 u_short R Device name 8
Return codes for command number 4
Return Code Description
00 OK
100 Pass code is incorrect
Other Invalid
Parameters for command number 5
Address Data Type Attribute Description
49025 u_short RW 5
49026 u_short R Return code
49027 u_short W Meter run (0…7)
49028 u_int W Pass code for user
49030…49034 — — Reserved
49035 u_short W 0: Disable
1: Enable
Parameters for command number 4 (Continued)
Address Data Type Attribute Description