Insert a scan block, Delete a scan block, Insert a scan block delete a scan block – Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 User Manual
Page 202
Publication 1758-UM002D-EN-P - October 2010
202 DataSite Flow Configuration Utility (DS FloConfig)
Insert a Scan Block
Follow these steps to insert a scan block.
1.
In the Scan Config window, select a scan block.
2.
Click Insert.
The Scan Edit dialog box appears.
3.
Enter the values for the scan block in the Scan Edit dialog box.
4.
To save the changes and close the Edit dialog box, click OK.
To close the Edit dialog box without saving, click Cancel.
Delete a Scan Block
Follow these steps to delete a scan block.
1.
Select the block you want to delete.
2.
Click Delete.
This manual is related to the following products: