Chapter 2, Datasite flow configuration utility (ds floconfig), Introduction – Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 User Manual
Page 107: Hardware and software requirements, Introduction hardware and software requirements, Chapter
107
Publication 1758-UM002D-EN-P - October 2010
Chapter
2
DataSite Flow Configuration Utility
(DS FloConfig)
This chapter provides information on the configuration settings utility,
DS FloConfig.
Introduction
DS FloConfig is a configuration software for 1758-FLO DataSite controllers.
You can edit and modify parameters for the flow computer, such as
AGA3/AGA7 algorithm selection, AGA3/AGA7 process parameters, and
AGA8 parameters.
DS FloConfig software can display real-time measurement data of each meter
run. You can also view and search historical transaction records and event
records. The parameter configuration can be saved into a project file for ease
of use.
Hardware and Software
Requirements
To install DS FloConfig, you need the following:
•
An IBM-compatible PC with at least a 80486 microprocessor
(Pentium-166 and above),
•
a CD-ROM drive,
•
at least 70 MB of free hard disk space,
•
at least 32 MB of memory (64 MB recommended),
•
A VGA graphic card, and
•
Windows NT 4.0, Windows 2000, or Windows XP Professional.
IMPORTANT
Use this tool to configure the 1758-FLO DataSite
controllers only.