Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 123)

Publication 1758-UM002D-EN-P - October 2010
DataSite Flow Configuration Utility (DS FloConfig) 123
Set the Contract Time
Contract time is the start time in a contract day. This is when the DataSite
controller starts taking and recording measurements.
The default contract time is 8:0:0.
Follow this step to display the current contract time.
• Under Contract Time, click Read.
Follow these steps to set the contract time.
1. Under Contract Time, enter the desired contract time in the Hour and
Minute boxes. For example, if you want to set 7.30 a.m. as the new
contract time, enter "7" in the Hour box and "30" in the Minute box.
The value of seconds is not editable and the default value is 0.
2. Under Contract Time, click Write.
The new contract time is applied to the DataSite controller.