Rockwell Automation 1758-RTU202 DataSite Software User Manual FRN 1.2 - Manual (Page 113)

Publication 1758-UM002D-EN-P - October 2010
DataSite Flow Configuration Utility (DS FloConfig) 113
2. If you have chosen UDP, set up the parameters for the TCP/IP
connection.
3. If you have chosen a COM port, set up the parameters for the serial port
connection.
Parameters for TCP/IP communication
Parameter Description Default Value
Station number Station corresponding to the DataSite
controller communication Ethernet port. 1
IP address IP address corresponding to the Ethernet
communication port of the DataSite
controller. The address is in the format,
xxx.xxx.xxx.xxx, made up of four octets with
each octet ranging between 0 and 255. 192.168.100.75
Port no. Port corresponding to the DataSite
controller. 502
Parameters for serial port communication
Parameter Value range Default Value
Station number 1…247 1
Baud rate (bps) 2400, 4800, 9600, 14400, 19200,
38400, 56000, 57600 9600