Lenze ECSCAxxx - Manual (Page 401)

Appendix
Code table
14
l
401 EDBCSXA064 EN 3.2
IMPORTANT Possible settings Code
Selection Lenze/
{Appl.} Designation No.
C0354 Alternative node address for
CAN_IN/CAN_OUT (CAN bus
interface X4) ^ 160
1 CAN addr. 129 1 {1} 512 Address 2 CAN1_IN
2 CAN addr. 1 Address 2 CAN1_OUT
3 CAN addr. 257 Address 2 CAN2_IN
4 CAN addr. 258 Address 2 CAN2_OUT
5 CAN addr. 385 Address 2 CAN3_IN
6 CAN addr. 386 Address 2 CAN3_OUT
C0355 Identifier for CAN_IN/CAN_OUT
(CAN bus interface X4)
Read only
^ 458
1 CAN Id 1 {1} 2047 Identifier CAN1_IN
2 CAN Id Identifier CAN1_OUT
3 CAN Id Identifier CAN2_IN
4 CAN Id Identifier CAN2_OUT
5 CAN Id Identifier CAN3_IN
6 CAN Id Identifier CAN3_OUT
C0356 CAN time settings for CAN bus
interface X4 ^ 163
1 CAN times 3000 0 {1 ms} 65000 CAN boot−up time:
Delay time after mains
connection for initialisation
through the master.
2 CAN times 0 CAN2...3_OUT cycle times:
Factor for the task time to send
process data telegram.
0 = event−controlled
transmission
3 CAN times 0
4 CAN times 20 Delay time for initial
transmission of the process data
objects 2 and 3 after the CAN bus
changed to "Operational"
C0357 Monitoring time for CAN1...3_IN
(CAN bus interface X4) ^ 202
1 CE monit time 3000 1 {1 ms} 65000 CE1 monitoring time
2 CE monit time 3000 CE2 monitoring time
3 CE monit time 3000 CE3 monitoring time
C0358 Reset node 0 Make a reset node for the CAN
bus node. ^ 279
0 No function
1 CAN reset
C0359 CAN state CAN bus status (interface X4)
Read only ^ 177
0 Operational
1 Pre−operational
2 Warning
3 Bus off
4 Stopped