Lenze ECSCAxxx - Manual (Page 103)

Commissioning
Commissioning steps (overview)
6
l
103 EDBCSXA064 EN 3.2
6.2 Commissioning steps (overview)
Start
Create a new project with the Drive PLC Developer
Studio (DDS) and load it into the ECSxA... axis module
,
DDS Manuals:
– Introduction in the IEC 61131−3 programming
– Getting started
– Reference Manual
Make the basic settings using the parameter setting
program Global Drive Control (GDC).
( ^ 104)
l Switch on the mains.
l Enable controller ( ^ 141).
l Save parameters in the controller with C0003 = 1.
l Save parameter set with GDC in the parameter set
file.
Optimise
drive behaviour
( ^ 141)
l Save parameters in the controller with C0003 = 1.
l Save parameter set with GDC in the parameter set
file.
End