8 can management, Can management – Lenze ECSCAxxx User Manual
Page 174
System bus (CAN / CAN−AUX) configuration
CAN management
l
174
EDBCSXA064 EN 3.2
8.8
CAN management
The system block CAN_Management
/CANaux_Management
ƒ
serves to activate a reset node to e.g. accept changes in the transfer rate and
addressing.
ƒ
serves to process statuses as Communication Error, Bus Off State, etc. in the PLC
program.
ƒ
serves to influence the transmission time of CAN2_OUT/CANaux2_OUT and
CAN3_OUT/CANaux3_OUT.
ƒ
serves to monitor the CAN communication.
I
Tip!
Detailed information on the SB CAN_Management can be found in chapter
13.6 (
¶ 277).
Detailed information on the SB CANaux_Management can be found in chapter
13.11 (
¶ 299).