3 node address (node id), Node address (node id), Aif interface (x1) configuration – Lenze ECSCAxxx User Manual
Page 184
AIF interface (X1) configuration
Node address (Node ID)
l
184
EDBCSXA064 EN 3.2
9.3
Node address (Node ID)
Assign each node within the system bus network to a node address ˘ also called node ID
˘ for a clear identification in the range 1 to 63.
The node address may not be assigned more than once within the network.
The node address for the AIF interface X1 of the ECSxA axis module is configured via code
C2350:
Code
Possible settings
IMPORTANT
No.
Designation
Lenze/ap
pl.
Selection
C2350 XCAN address
1
Node address XCAN
(AIF interface X1)
^ 184
1
{1}
63
Assignment of the node address for the data exchange between Lenze devices
If Lenze devices are assigned with node addresses in a complete ascending order, the
identifiers of the event−controlled data objects (XCAN2_IO/XCAN3_IO) are factory−set so
that the devices are able to communicate with each other:
L
Node-ID 1
XCAN2_OUT
XCAN2_IN
XCAN3_OUT
XCAN3_IN
L
Node-ID 2
XCAN2_OUT
XCAN2_IN
XCAN3_OUT
XCAN3_IN
L
Node-ID 3
Fig. 9−1
Data exchange between Lenze devices