Allied Telesis AT-S100 - Manual (Page 90)

Chapter 3: Privileged Executive Mode Commands
90 Section I: Command Modes
SHOW INTERFACE
Syntax
show interface IFNAME ge<1-28>
Parameters
IFNAME Specifies the name of an interface. There are 28 ports on
the AT-9000/28 and AT-9000/28SP switches. To specify
a port, precede the port number with “ge.”
Description
Use the SHOW INTERFACE command to display the configuration and
status of an interface. If you do not specify an interface, this command
displays the status of all the interfaces.
Command Mode
Privileged Executive mode
Example
The following is an example of the SHOW INTERFACE command on port
1 and the sample output:
switch#show interface ge1
Interface ge1
Hardware is Ethernet, address is 0004.2104.0801 (bia
004.2104.0801)
index 2001 metric 1 mtu 1500 duplex-full arp ageing
timeout 0
speed unknown mdix mdi
VRF Binding: Not bound
input packets 013884, bytes 01642232, multicast
packets 07691 broadcast packets 06185
64-byte packets 05968, 65-127 packets 05346, 128-255
packets 01293
245-511 packets 01366, 512-1023 packets 03, >1024 packets
00
dropped 00, jabber 00 CRC error 03 undersize frames 00
oversize frames 00, fragments 00 collisions 00
output packets 092, bytes 05898, multicast packets 092
broadcast packets 00