Allied Telesis AT-S100 - Manual (Page 148)

Chapter 4: Configuration Terminal Mode Commands
148 Section I: Command Modes
NTP SERVER
Syntax
ntp server WORD prefer|version <1-4>|key <1-
4294967295>
Parameters
WORD Indicates the IP address of the NTP server. Use the
following format:
xxx.xxx.xxx.xxx
prefer Specifies the software prefers this peer when possible.
version Indicates the NTP version. Specify versions 1 through 4.
key Indicates the peer key number that permits access to the
specified NTP server.
Description
Use the NTP SERVER command to specify the IP address of the NTP
server, a key to access the server, and the NTP version number. In
addition, you can specify if the software prefers this NTP server over other
NTP servers.
Note
To add more than one NTP server to the switch, enter a second
NTP SERVER command with another IP address.
For procedures to configure NTP, see “Setting the Network Time” on
page 29.
Command Mode
Configuration Terminal mode
Example
The following example sets the IP address of the NTP server to 198.11.1.9
and shows the resulting display:
switch#configure terminal