Allied Telesis AT-S100 - Manual (Page 168)

Chapter 5: Interface Configuration Mode Commands
168 Section I: Command Modes
FLOW CONTROL BACKPRESSURE
Syntax
flow control backpressure on|off
Parameters
backpressure Specifies back-pressure flow-control in half-duplex mode.
Choose from the following options.
on Enables back pressure.
off Disables back pressure.
Description
Use the FLOWCONTROL BACKPRESSURE command to enable or
disable back-pressure flow-control on an interface.
Command Mode
Interface Configuration mode
Example
The following commands turn on back-pressure flow-control in half-duplex
mode on port 4:
switch#configure terminal
switch(config)#interface ge4
switch(config-if)#flowcontol backpressure on
Related Commands
“FLOW CONTROL SEND” on page 170
“FLOW CONTROL RECEIVE” on page 169