Allied Telesis AT-S100 - Manual (Page 222)

Chapter 8: Port Security Commands
222 Section II: Advanced Configuration
SWITCHPORT PORT-SECURITY MAXIMUM
Syntax
switchport port-security maximum <1-320>
no switchport port-security maximum <1-320>
Parameters
maximum Sets the maximum number of MAC addresses that can be
accepted by the port. Choose a value between 1 and 320.
Description
Use the SWITCHPORT PORT-SECURITY MAXIMUM command to set
the maximum number of secure MAC addresses that can be learned by
the specified port.
Use the no form of this command to remove maximum the port-security
setting.
To display the current port security settings, use the “SHOW RUNNING-
CONFIG INTERFACE” on page 160.
Command Mode
Interface Configuration mode
Example
The following commands set the maximum number of secure addresses
learned on port 15 to 40:
switch#configure terminal
switch(config)#interface ge15
switch(config-if)#switchport port-security maximum 40
Related Commands
“SWITCHPORT PORT-SECURITY MODE” on page 223
“SWITCHPORT TRUNK ALLOWED VLAN” on page 190