Allied Telesis AT-S100 - Manual (Page 160)

Chapter 4: Configuration Terminal Mode Commands
160 Section I: Command Modes
SHOW RUNNING-CONFIG INTERFACE
Syntax
show running-config interface INTERFACE
Parameters
IFNAME Specifies the name of an interface. There are 28 ports on
the AT-9000/28 and AT-9000/28SP switches. To specify
a port, precede the port number with “ge.”
Note
Do not mix interface types in a list. Also, the specified interfaces
must exist.
Description
Use the SHOW RUNNING-CONFIG INTERFACE command to display the
current configuration of one or more interfaces on the device.
Command Mode
All modes
Examples
To display the status of the SHOW RUNNING-CONFIG INTERFACE
command on port 4:
switch#show running-config interface ge4
See Figure 19 for an example display.
Figure 19. SHOW RUNNING-CONFIG INTERFACE Port Example
To display the status of the current running configuration of a switch for
VLAN 1:
switch#show running-config interface vlan1
(switch3)# show running-config interface ge4
!
interface ge4
static channel-group 3