Allied Telesis AT-S100 - Manual (Page 182)

Chapter 5: Interface Configuration Mode Commands
182 Section I: Command Modes
SPEED
Syntax
speed
10000mfull|1000mfull|100mfull|100mhalf|100fx|10mfull|
10mhalf|auto
no speed
Parameters
10000mfull Specifies the interface is forced to operate at a speed of
10,000 Mbps in full duplex mode.
1000mfull Specifies the interface is forced to operate at a speed of
1,000 Mbps in full duplex mode.
100mfull Specifies the interface is forced to operate at a speed of
100 Mbps in full duplex mode.
100mhalf Specifies the interface is forced to operate at a speed of
100 Mbps in half duplex mode.
100fx Specifies the interface is forced to operate at a speed of
100FX on an uplink port that is connected to an SFP
transceiver. This setting applies to ports 25 through 28
on the AT-9000/28 switch. On the AT-9000/28SP
switch, this setting applies to all of the ports. This speed
is available in full-duplex mode only.
10mfull Specifies the interface is forced to operate at a speed of
10 Mbps in full duplex mode.
10mhalf Specifies the interface is forced to operate at a speed of
10 Mbps in half duplex mode.
auto Enables auto speed and duplex configuration.
Description
Use the SPEED command to set the speed and duplex mode for each port
on the switch. For ports ge24 through ge28, you need to manually set the
port speed to 100FX when you insert an SFP.
Use the no form of this command to remove the interface speed.