Allied Telesis AT-S100 - Manual (Page 35)

AT-S100 Management Software User’s Guide
35
Rebooting the
Switch
To reboot the switch, enter the following command:
switch# system reboot
When you enter this command the switch temporarily loses power and will
the current session is lost. To start a new session on the switch, log in
again.
For more information about this command, see “SYSTEM REBOOT” on
page 112.
Resetting Switch
to Factory
Default Values
To reset the AT-S100 software to its factory default values, enter the
following command:
switch# system factory-reset
Warning
This command does not save your current configuration. To save
your current configuration, see “COPY DEFAULT.CFG” on page 84.
For more information about this command, see “SYSTEM FACTORY-
RESET” on page 111.
Upgrading or
Downgrading
Software
To upgrade an AT-9000 switch with the latest version of the AT-S100
software, you need to download the software onto your switch with an
TFTP server. To obtain the latest version of the AT-S100 software, go to
our website, www.alliedtelesis.com and copy it on your PC.
You can use the following procedure to upgrade the AT-S100 software
image file to the latest version or downgrade the software to an earlier
version. However, it is unlikely that you would want to downgrade the
current version of the AT-S100 software to an earlier version.
Note
You do not need to upgrade the bootloader file.
Upgrading or Downgrading the AT-S100 Software with a TFTP
Server
Use the following procedure to upgrade or downgrade the AT-S100
software with a TFTP server.
1. Check the current software version installed on your switch, enter the
SHOW VERSION command.
See below for a sample output of the SHOW VERSION command:
(switch)#show version
Product ID=ATS100