Allied Telesis AT-S100 - Manual (Page 133)

AT-S100 Management Software User’s Guide
Section I: Command Modes 133
IP SSH RSA KEYPAIR-NAME
Syntax
ip ssh rsa keypair-name WORD
no ip ssh rsa keypair-name
Parameters
WORD Specifies a name of an RSA keypair.
Description
Use the IP SSH RSA KEYPAIR-NAME command to set the name of an
RSA keypair.
Use the no form of this command to remove an RSA keypair.
Command Mode
Configuration Terminal mode
Example
The following commands set the keypair name to “ssh_host_rsa_key5:”
switch#configure terminal
switch(config)#ip ssh rsa keypair-name
ssh_host_rsa_key5
Related Commands
“IP SSH VERSION” on page 134