Allied Telesis AT-S100 - Manual (Page 233)

AT-S100 Management Software User’s Guide
Section II: Advanced Configuration 233
SNMP-SERVER GROUP
Syntax
snmp-server group GROUPNAME v1|v2c auth|noauth|priv
|read[VIEWNAME]|write[VIEWNAME]|notify[VIEWNAME]
no snmp-server group GROUPNAME v1|v2c
Parameters
GROUPNAME Specifies the group name. Choose an alphanumeric
value between 1 and 255 characters.
v1 Specifies a group that uses the SNMPv1 security mode.
v2c Specifies a group that uses the SNMPv2c security mode.
read Specifies the view that permits the user read access.
VIEWNAME Indicates a name of a view defined with
the SNMP-SERVER VIEW command.
write Specifies the view that the user is allowed to read and
write.
VIEWNAME Indicates a name of a view defined with
the SNMP-SERVER VIEW command.
notify Specifies the view that permits a user to be notified.
VIEWNAME Indicates a name of a view defined with
the SNMP-SERVER VIEW command.
Description
Use the SNMP-SERVER GROUP command to define the access rights for
an SNMP group that you created with the SNMP-SERVER USER
command. The SNMP-SERVER GROUP command assigns a security
model and a security level to a group.
Use the no form of this command to remove an SNMP group.
Command Mode
Configuration Terminal mode