Allied Telesis AT-S100 - Manual (Page 131)

AT-S100 Management Software User’s Guide
Section I: Command Modes 131
IP IGMP SNOOPING
Syntax
ip igmp snooping
no ip igmp snooping
Description
Use the IP IGMP SNOOPING command to enable IGMP Snooping on the
switch. When you enter this command at the Configuration Terminal
mode, IGMP Snooping is enabled on the switch. By default, the IP IGMP
Snooping feature is enabled.
Use the no parameter with this command to globally disable IGMP
Snooping for the specified interface.
Command Mode
Configuration Terminal mode
Example
Use the following commands to enable IGMP Snooping on the switch:
switch#configure terminal
switch(config)#ip igmp snooping
Related Commands
none