Allied Telesis AT-S100 - Manual (Page 175)

AT-S100 Management Software User’s Guide
Section I: Command Modes 175
MDIX
Syntax
mdix mdi|mdix
Parameters
mdi Specifies the interface is forced to MDI mode.
mdix Specifies the interface is forced to MDIX mode.
Description
Use the MDIX command to force an interface to the MDI or MDIX mode.
This command only applies to copper ports 1-24 on the AT-9000/28
switch. The MDIX command does not apply to fiber ports.
Command Mode
Interface Configuration mode
Example
The following commands force interface 7 to MDI mode:
switch#configure terminal
switch(config)#interface ge7
switch(config-if)#mdix mdi
Related Commands
“SPEED” on page 182