Allied Telesis AT-S100 - Manual (Page 237)

AT-S100 Management Software User’s Guide
Section II: Advanced Configuration 237
SNMP-SERVER USER
Syntax
snmp-server user USERNAME GROUPNAME remote HOST
udpport <1-65536> v1|v2 auth(md5|sha) auth-password
no snmp-server user USERNAME
Parameters
USERNAME Specifies the name of the user.
GROUPNAME Specifies the name of the SNMP group. The user
listed in this command becomes a member of this
group.
HOST Specifies the IP address of the host that connects to
the agent in the following format:
xxx.xxx.xxx.xxx
udp-port Specifies a UDP port value. Enter a value between 1
and 65536. The default value is 162.
v1 Specifies the SNMPv1 security mode.
v2c Specifies the SNMPv2c security mode.
auth Specifies authentication is used to verify the server. If
you select this parameter, you must specify an auth-
password.
md5 Specifies the MD5 security mode. This is an
optional parameter.
sha Specifies the SHA security mode. This is an
optional parameter.
auth-password Specifies the SNMP authorization password.
Description
Use the SNMP-SERVER USER command to create an SNMP user,
create an SNMP group, and assign the user to an SNMP group. In
addition, the SNMP-SERVER USER command maps a security mode,
authentication mode, and authorization password to a group name.
Use the no form of the SNMP-SERVER USER command to remove an
SNMP user from a group.