Allied Telesis AT-S100 - Manual (Page 166)

Chapter 5: Interface Configuration Mode Commands
166 Section I: Command Modes
DOT1X PORT-CONTROL
Syntax
dot1x port-control auto|force-authorized|force-
unauthorized dir=both|in
no dot1x port-control
Parameters
force-authorized Forces an interface to an authorized state.
force-unauthorized Forces an interface to an unauthorized state.
auto Allows a client to negotiate authentication on an
interface.
dir Specifies the packet control direction, where:
both Discards receive and transmit packets from
the supplicant.
in Discards receive packets from the
supplicant.
Description
Use the DOT1X PORT-CONTROL command to force a port state on an
interface. To remove an interface from the 802.1x management, use the
no form of this command.
Command Mode
Interface mode
Example
The following commands enable authentication on interface 20:
switch# configure terminal
switch(config)# interface ge20
switch(config-if)# dot1x port-control auto
Related Commands
none