Allied Telesis AT-S100 - Manual (Page 144)

Chapter 4: Configuration Terminal Mode Commands
144 Section I: Command Modes
<0-7> Specifies the priority for queue 6, where 0 indicates strict
priority.
<0-10> Specifies the weight for queue 7, where 0 indicates strict
priority.
<0-7> Specifies the priority for queue 7, where 0 indicates strict
priority.
Description
The MLS QOS command to define queues for the Quality of Service
feature. This command configures the default queues for any packet
arriving on the specified interface. You must configure all of the queues.
Use the no form of this command to turn off the use of a default queue.
Command Mode
Configuration Terminal mode
Example
The following example sets queue 0 with a weight of 10 and a priority of 7,
queue 1 with a weight of 9 and a priority of 6, and the remaining queues
with a weight of 1 and a priority of 1:
switch# configure terminal
switch#(config)# mls qos 10 7 9 6 1 1 1 1 1 1 1 1 1 1 1
1
Related Commands
“USER-PRIORITY” on page 193