Allied Telesis AT-S100 - Manual (Page 111)

AT-S100 Management Software User’s Guide
Section I: Command Modes 111
SYSTEM FACTORY-RESET
Syntax
system factory-reset
Parameters
none
Description
Use the SYSTEM FACTORY-RESET command to reset the AT-S100
software to the factory default settings. When you enter this command,
you will lose the running configuration.
Caution
Before you enter this command, you may want to copy your current
configuration. See “COPY” on page 81.
Command Mode
Privileged Executive mode
Example
The following command sets the AT-S100 software to the factory default
settings:
switch# system factory-reset
You are prompted with the following questions:
Will lose running configuration and system will reboot?
(Y/N)
To continue, enter Y for yes.
Related Commands
“COPY” on page 81
“SYSTEM REBOOT” on page 112