Allied Telesis AT-S100 - Manual (Page 225)

AT-S100 Management Software User’s Guide
Section II: Advanced Configuration 225
SWITCHPORT PORT-SECURITY VIOLATION
Syntax
switchport port-security violation
protect|restrict|shutdown
no switchport port-security violation
protect|restrict|shutdown
Parameters
violation Sets the security mode. Choose from the following options:
protect Permits traffic from a secure port only. Drops
packets from insecure ports. This is the least
secure option.
restrict Sends an alert when security violation is detected.
shutdown Shuts down port if a security violation is detected.
Description
Use the SWITCHPORT PORT-SECURITY VIOLATION command to set a
port’s security mode. This is the action the software takes when the port
has exceeded its maximum number of MAC addresses. Only one mode
can be active on a port at a time. By default, no port-security mode is
configured on an interface.
The no form of this command removes the current setting.
To display the current port security settings, use the “SHOW RUNNING-
CONFIG INTERFACE” on page 160.
Command Mode
Interface Configuration mode