Allied Telesis AT-S100 - Manual (Page 230)

Chapter 9: Simple Network Management Protocol (SNMP) Commands
230 Section II: Advanced Configuration
SNMP-SERVER CONTACT
Syntax
snmp-server contact LINE
no snmp-server contact
Parameters
LINE Specifies an alphanumeric string including spaces. You do
not have to use quotation marks to indicate spaces.
Choose a value that is between 1 and 255 characters in
length.
Description
Use the SNMP-SERVER CONTACT command to set a contact person,
email address, or IP address for the SNMP system. To remove a contact
from the SNMP server, use the no form of this command.
Command Mode
Configuration Terminal mode
Examples
The following commands set the SNMP server contact to
[email protected]:
switch#configure terminal
switch#(config)#snmp-server contact
[email protected]
The following commands set the SNMP server contact to “Todd Marcus:”
switch#configure terminal
switch#(config)#snmp-server contact Todd Marcus
The following commands set the SNMP server contact to IP address
192.34.12.4:
switch#configure terminal
switch#(config)#snmp-server contact 192.34.12.4