Allied Telesis AT-S100 - Manual (Page 145)

AT-S100 Management Software User’s Guide
Section I: Command Modes 145
NTP AUTHENTICATE
Syntax
ntp authenticate
no ntp authenticate
Parameters
none
Description
Use the NTP AUTHENTICATE command to enable authentication of the
Network Time Protocol (NTP) time source. By default, this command is
disabled. To disable NTP authentication on the switch, use the no form of
this command.
For procedures to configure NTP, see “Setting the Network Time” on
page 29.
Command Mode
Configuration Terminal mode
Example
The following commands enable authentication of the NTP time source:
switch#configure terminal
switch(config)#ntp authenticate
Related Commands
“CLOCK SUMMER-TIME RECURRING” on page 117
“CLOCK TIMEZONE” on page 119
“NTP TRUSTED-KEY” on page 150