Allied Telesis AT-S100 - Manual (Page 132)

Chapter 4: Configuration Terminal Mode Commands
132 Section I: Command Modes
IP ROUTE
Syntax
ip route (GATEWAYIP|INTERFACE)
no ip route (GATEWAYIP|INTERFACE)
Parameters
GATEWAYIP Indicates the IPV4 address and subnet mask of the
gateway device in the following format:
000.000.000/0
INTERFACE Specifies a the name of the interface (in the range of
ge1 through ge28) that connects your device to the
network.
Description
Use the IP ROUTE command to add a gateway address to the switch. Use
the no form of this command to remove the static route from the switch.
Command Mode
Configuration Terminal mode
Examples
The following example sets the gateway IP address to 0.0.0.0 and a
subnet mask of 0:
switch#configure terminal
switch(config)#ip route 0.0.0.0/0
Related Commands
“IP ADDRESS” on page 117
“IP ADDRESS DHCP” on page 119