Allied Telesis AT-S100 - Manual (Page 268)

Chapter 11: Virtual Local Area Networks (VLAN) Commands
268 Section II: Advanced Configuration
VLAN ACCESS-MAP
Syntax
vlan access-map NAME <1-65535>
Parameters
NAME Specifies the name of the access map and the sequence to
insert or delete it from an existing access-map entry.
Command Mode
Configuration Terminal mode
Description
Use the VLAN ACCESS-MAP command to create a VLAN access-map,
name it, and determine the sequence to insert it to or delete it from an
existing access map entry.
Example
The following commands create a VLAN access-map named “Map 4” and
gives it a priority of 1:
switch# configure terminal
switch(config)# vlan access-map “Map 4” 1
Related Commands
“VLAN” on page 267