Allied Telesis AT-S100 - Manual (Page 213)

AT-S100 Management Software User’s Guide
Section II: Advanced Configuration 213
SET GVRP APPLICANT
Syntax
set gvrp applicant state active|normal ge<1-28>
Parameters
active Indicates the active state. The port participates in GVRP. The
port processes GVRP information and transmits PDUs.
normal Indicates the normal state.The port does not participate in
GVRP. The port neither processes GVRP information nor
transmits PDUs.
ge<1-28> Specifies the name of an interface. There are 28 ports on the
AT-9000/28 and AT-9000/28SP switches. To specify a port,
precede the port number with “ge.”
Description
The GVRP APPLICANT command sets the GID applicant state on a port
to active or normal.
Command Mode
Configuration Terminal mode
Examples
The following commands set the GID applicant on port 5 to an active state:
switch#configure terminal
switch(config)#set gvrp applicant state active ge5
Related Commands
“SET GVRP” on page 212
“SET GVRP DYNAMIC-VLAN-CREATION” on page 214
“SET GVRP REGISTRATION” on page 215
“SET GVRP TIMER” on page 217