Allied Telesis AT-S100 - Manual (Page 184)

Chapter 5: Interface Configuration Mode Commands
184 Section I: Command Modes
STATIC-CHANNEL-GROUP
Syntax
static-channel-group <1-8>
no static-channel-group
Parameters
<1-8> Specifies the static-channel-group number.
Description
Use the STATIC-CHANNEL-GROUP command to create a static-channel
group.
Use the no form of this command to remove a static-channel group.
Command Mode
Interface Configuration mode
Example
The following commands create channel group 2 on port 8:
switch#configure terminal
switch(config)#interface ge8
switch(config-if)#static-channel-group 2
Related Commands
“SHOW STATIC-CHANNEL-GROUP” on page 109