Allied Telesis AT-S100 - Manual (Page 36)

Chapter 2: Configuring the AT-S100 Software
36
Application Version=1.0.3
Application BuildTime=12:47:47
Application BuildDate=Nov 21 2008
Serial Number=
Model=AT-9000/28
Ethaddr=
Baudrate=9600
Uptime= 16:01:02 up 1 min, load average:
0.21, 0.08, 0.02
HwRev=B
2. Assign an IP address and subnet mask to the switch with the IP
ADDRESS A.B.C.D/mask command.
The following commands set VLAN 1 with the primary IP address and
mask of 192.0.0.1/8.
switch#configure terminal
switch(config)#interface vlan1
switch(config-if)#ip address 192.0.0.1/8
Caution
Make sure the IP address of the TFTP server is in the same subnet
as the IP address of the switch.
3. Save your configuration by entering the following command:
switch#copy running-config startup-config
4. Use the DOWNLOAD command to download the image file from the
TFTP server onto the switch.
The following command uses a TFTP server, with an IP address of
189.11.1.1, to download the “ATS100_ATI_v103.img” file onto the
switch:
switch#download tftp 189.11.1.1 ATS100_ATI_v103.img
The following is displayed:
TFTP IP 189.11.1.1, file name
ATS100_ATI_v103.img