Allied Telesis AT-S100 - Manual (Page 71)

Section I: Command Modes 71
Chapter 3
Privileged Executive Mode Commands
This chapter describes the commands in the Privileged Executive mode
which are used to perform general switch functions such as copying
configuration file and displaying interface and MAC address table
information. This chapter contains the following commands:
ˆ “CLEAR MAC ADDRESS-TABLE DYNAMIC” on page 73
ˆ “CLEAR MAC ADDRESS-TABLE MULTICAST” on page 75
ˆ “CLEAR MAC ADDRESS-TABLE STATIC” on page 77
ˆ “CONFIGURE TERMINAL” on page 79
ˆ “COPY” on page 81
ˆ “COPY A.B.C.D” on page 82
ˆ “COPY DEFAULT.CFG” on page 84
ˆ “CP” on page 86
ˆ “DOWNLOAD TFTP” on page 87
ˆ “EXIT” on page 88
ˆ “LOGOUT” on page 89
ˆ “SHOW INTERFACE” on page 90
ˆ “SHOW MAC ADDRESS-TABLE” on page 92
ˆ “SHOW MAC ADDRESS-TABLE AGEING-TIME” on page 94
ˆ “SHOW MAC ADDRESS-TABLE DYNAMIC” on page 96
ˆ “SHOW MAC ADDRESS-TABLE INTERFACE” on page 98
ˆ “SHOW MAC ADDRESS-TABLE STATIC” on page 100
ˆ “SHOW MAC ADDRESS-TABLE VLAN Command” on page 103
ˆ “SHOW RUNNING-CONFIG INTERFACE” on page 104
ˆ “SHOW SPANNING-TREE” on page 106
ˆ “SHOW STATIC-CHANNEL-GROUP” on page 109
ˆ “SHOW USER-PRIORITY” on page 110
ˆ “SYSTEM FACTORY-RESET” on page 111
ˆ “SYSTEM REBOOT” on page 112
ˆ “UPLOAD TFTP” on page 113