Allied Telesis AT-S100 - Manual (Page 139)

AT-S100 Management Software User’s Guide
Section I: Command Modes 139
MAC ADDRESS-TABLE STATIC DISCARD
Syntax
mac address-table static MAC discard interface IFNAME
vlan VLANID
no mac address-table static
Parameters
MAC Indicates the static MAC address in the following
format:
MMMM.MMMM.MMMM
IFNAME Specifies the name of an interface. There are 28 ports
on the AT-9000/28 and AT-9000/28SP switches. To
specify a port, precede the port number with “ge.”
VLANID Indicates the VLAN interface. Enter a value between 2
and 4,094. If you do not enter a value, VLAN 1 is
assumed by default.
Description
Use the MAC ADDRESS-TABLE STATIC DISCARD command to delete
an entry in the MAC address table. The switch forwards packets with the
specified source or destination MAC address. Only unicast static
addresses are supported. By default, this command is disabled.
Use the no form of this command to reset it.
For procedures to configure and display the MAC addresses, see
“Displaying and Setting MAC Addresses” on page 32.
Command Mode
Configuration Terminal mode
Example
The following example deletes the MAC address “000C.6E73.2BC4” on
interface 4 on VLAN 9:
switch# configure terminal
switch#(config)# mac address-table static
000C.6E73.2BC4 discard interface ge4 vlan 9