Allied Telesis AT-S100 - Manual (Page 127)

AT-S100 Management Software User’s Guide
Section I: Command Modes 127
HELP
Syntax
help
Parameters
none
Description
Use this command to display information about the CLI. The HELP
command provides information about the current parameter. There are
two forms of the HELP command:
ˆ Full help is available when you enter a command followed by a space
and the question mark (?). This displays all of the parameters for the
command.
ˆ Partial help is available when you enter an abbreviated command or
argument immediately followed by the question mark (?) without a
space. For example, “show con?” In this case, the software responds
by displaying, “SHOW CONFIGURE.”
Command Mode
All modes
Examples
The following is an example of full help and the resulting display:
switch#clear ?
ip Internet Protocol (IP)
mac Clear layer 2 MAC entries
spanning-tree spanning-tree
The following is an example of the partial help and the resulting display:
switch#snmp-server u?
switch#snmp-server user
Related Commands
none