Allied Telesis AT-S100 User Manual
Page 64
Chapter 2: Configuring the AT-S100 Software
64
The syntax of this command is:
show spanning-tree
To display the current spanning tree settings for the STP mode, enter the
following commands:
switch# configure terminal
switch(config)# spanning-tree mode stp
switch(config)# show spanning-tree
For more information about this command including a display, see “SHOW
SPANNING-TREE” on page 244.
Enabling or Disabling the Spanning Tree Mode
To enable or disable the spanning tree mode on the switch, use the
SPANNING-TREE ENABLE FORWARD command. The syntax of this
command is:
spanning-tree stp|rstp enable forward
To enable STP, enter the following commands:
switch# configure terminal
switch(config)# spanning-tree stp enable forward
To disable the RSTP on the switch, enter the following commands:
switch# configure terminal
switch(config)# no spanning-tree rstp enable forward
For more information about this command, see “SPANNING-TREE
ENABLE FORWARD” on page 247.
Setting Spanning-Tree Priority
Use the SPANNING-TREE PRIORITY command to specify the interface
priority for the switch. A lower priority value indicates a greater likelihood
of becoming a root. The default value is 32,768.
The syntax of this command is:
spanning-tree priority (0-61440)