Allied Telesis AT-S100 - Manual (Page 124)

Chapter 4: Configuration Terminal Mode Commands
124 Section I: Command Modes
ENABLE PASSWORD
Syntax
enable password (8) LINE
Parameters
8 Specifies a hidden password will follow. This is an optional
parameter.
LINE Specifies a password for the Privileged Executive Mode.
Enter an alphanumeric value.
Description
Use the ENABLE PASSWORD command to assign a password for the
commands in the Privileged Executive mode. By default, there is no
password assigned for this mode. For information about the Privileged
Executive mode commands, see “Privileged Executive Command Mode”
on page 18.
Command Mode
Configuration Terminal mode
Example
The following commands assign the Privileged Executive mode password
to “rose7:”
switch#configure terminal
switch(config)#enable password rose7
Related Commands
“ENABLE SECRET” on page 125